Samsung Washer LE Error: Water leak detected
If your Samsung appliance is showing this error, you’re dealing with a samsung washer le error. Here’s everything you need to know about diagnosing and fixing this issue. Samsung le error code — here is what you need to know. What Does Error Code LE Mean on a Samsung Washer? Error code LE on Samsung […]
Sometimes
DIY Fixable
From $150
Typical Repair Cost
45-90 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
No. Do not continue using the washer with an active LE error. Water leaks can damage flooring, promote mold growth, and create an electrical shock hazard if water contacts the motor or control board wiring.
Can I reset the code?
Yes. Power off the washer for 60 seconds to reset the LE code. However, the code will return if the underlying leak is not resolved. Address the leak source before restarting.
When to stop immediately?
Stop if you notice: Water is actively dripping or flowing from the machine, You smell burning or see sparks near the base of the washer.
Symptoms You May Notice
Water pooling under the washer
Visible water accumulation on the floor around or beneath the washing machine during or after a cycle.
LE or LE1 code on display panel
The control panel shows LE indicating the internal float switch or moisture sensor has triggered.
Cycle stops mid-wash unexpectedly
The machine abruptly halts its current cycle and may attempt to drain any remaining water.
Musty or mildew smell near machine
Persistent moisture from a slow leak causes mold growth in the base pan or behind the unit.
Possible Causes
Loose or damaged drain hose
The drain hose connection at the pump or standpipe can work loose over time due to vibration, or the hose itself may crack from age or chemical exposure.
DIY PossibleWorn tub-to-pump boot seal
The rubber boot connecting the outer tub to the drain pump develops cracks from hot water exposure and detergent chemicals, allowing water to seep into the base pan.
Requires ProfessionalExcessive detergent or non-HE soap
Using too much detergent or regular (non-HE) detergent creates overflow suds that bypass the door seal or tub rim, dripping water into areas that trigger the leak sensor.
DIY PossibleSafe Checks You Can Do
-
1
Inspect hose connections
Turn off the water supply valves and disconnect power. Pull the washer away from the wall and check both fill hose connections and the drain hose for looseness, cracks, or moisture.
Run your finger along each connection — even a slight dampness indicates the leak source.
-
2
Check detergent usage
Verify you are using HE-rated detergent and following the dosage guidelines in your Samsung manual. For the Bespoke AI series, the auto-dispenser handles dosing — check that the dispenser is not overfilled.
Samsung recommends no more than 2 tablespoons of HE liquid detergent per full load.
-
3
Run a short test cycle
After tightening any loose connections and reducing detergent, run a quick wash cycle and observe the base of the machine with a flashlight. If water still appears, the leak is internal.
Place paper towels under the machine to pinpoint exactly where drips originate.
When to Call a Professional
Contact a qualified technician if:
- Leak appears to come from the center or bottom of the machine, not the hoses
- The door gasket on a front-loader is visibly torn, cracked, or deformed
- LE code persists after verifying all external connections are secure and tight
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Washer Repair Service Schedule Appointment