Samsung Dryer DC Error: Door opened mid-cycle
If your Samsung appliance is showing this error, you’re dealing with a samsung dryer dc error. Here’s everything you need to know about diagnosing and fixing this issue. Samsung dc error code — here is what you need to know. What Does Error Code dC Mean on a Samsung Dryer? Error code dC on Samsung […]
Yes
DIY Fixable
From $80
Typical Repair Cost
10-20 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Yes. dC is a normal safety response to the door opening. Once the door is closed and the cycle is resumed, the dryer operates normally. Frequent unintended dC codes indicate a latch or switch issue that should be addressed but is not dangerous.
Can I reset the code?
Yes. Close the door firmly and press Start. The dC code clears immediately once the door switch confirms closure. No power cycling is needed.
When to stop immediately?
Stop if you notice: The door will not stay latched — it pops open repeatedly, Hot air blasts out when the door opens (indicating the heater did not shut off).
Symptoms You May Notice
Dryer stops tumbling during cycle
The drum ceases rotation mid-cycle and the heater turns off as the dryer detects a door-open condition.
dC displayed on control panel
The display shows dC, indicating the door switch lost its closed signal during operation.
Door pops open during tumbling
The dryer door physically opens slightly during operation, especially during cycles with a heavy load that causes vibration.
Cycle will not resume after closing door
After closing the door, pressing Start does not resume the cycle because the switch is not re-registering closure.
Possible Causes
User opened the door
The door was intentionally opened to check on clothes, add an item, or remove lint from the screen mid-cycle.
DIY PossibleWorn door latch
The door catch or strike plate has worn to the point where vibration during tumbling can bounce the door open, breaking the switch contact.
DIY PossibleIntermittent door switch
The door switch contacts are worn and occasionally lose continuity even though the door is physically closed and latched.
Requires ProfessionalSafe Checks You Can Do
-
1
Close door and resume
Push the door firmly closed until you hear the latch click, then press Start/Pause to resume the drying cycle.
Check whether any clothes are caught in the door opening that might prevent a full seal.
-
2
Inspect the latch
Look at the door catch and the strike plate for visible wear, cracks, or lint buildup. Clean the latch area with a damp cloth.
A worn catch can sometimes be temporarily fixed by bending the metal strike slightly inward for a tighter grip.
When to Call a Professional
Contact a qualified technician if:
- dC appears on every cycle without anyone near the dryer
- The door latch is physically broken and cannot hold the door shut
- The door switch does not click when tested by hand
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Dryer Repair Service Schedule Appointment